Serving Eugene, Greater Portland, Vancouver, Everett, Bellingham, and Nearby Areas
Click on a photo to enlarge.
This Crawlspace Entrance was a muddy mess, that really was difficult to maneuver through. When we did a full Crawlspace Encapsulation we revamped the entrance with a Turtl entryway.
This homes old 6 Mil vapor barrier was holding up generally well against the groundwater, however, the space suffered from high humidity, leaving the fiberglass insulation water heavy and falling out of place. The only real way to insulate a crawlspace and protect your home is a full encapsulation. This properly insulated the space, and waterproofs it, keeping your home dry and healthy.
This homes crawl space needed some upkeep. It had been sitting unattended to for over five years and the old vapor barrier had a layer of dust. The fiberglass had been sealed up, but it was damp and held an unhealthy level of moisture in it that was growing mold spores. To protect the home from water damage, the homeowners wanted to look into encapsulation. Our design specialist went out and did a full inspection. After going over how an encapsulation could help, they were ready to move forward.
This homeowner had lived in their home for over a year and noticed there was a crack on one side of the foundation. Due to the fear of water getting into their crawl space from that crack, they decided to inspect and found mold growing all over in their crawl space. This meant that moisture was getting in and was creating an unhealthy environment that was affecting the home and its occupants' health. They called John's Waterproofing about what options they had to eliminate the mold and protect their home against future moisture. They agreed a full encapsulation would be necessary. To begin, we had to remove the previous vapor barrier that water had destroyed and take out all the insulation and apply MoldX as needed. Then, we installed a drainage system. This includes digging a trench along the interior perimeter of the crawl space and laying a perforated pipe. The pipe collects any water that may seep in and gives it a safe passageway to flow through. It connects to a TripleSafe sump pump. This three-pump system is designed to push water out and send it away from the homes foundation. Once drainage is installed, then we need to insulate. TerraBlock, a 3/4 in thick foam, is installed as insulation along the base of the crawl space. This aids in keeping moisture out, but also insulates to help with energy efficiency. We then installed a CleanSpace vapor barrier. This vapor barrier goes on top of the insulation foam and between the concrete footing and wooden posts to isolate them and protect against water damage. CleanSpace is also installed up the foundation walls to act as a guide for moisture to be directed down to the drainage system. A SaniDry dehumidifier is installed to help pull moisture out of the air and control the environment. This maintains humidity levels, thus protecting against mold. After this encapsulation is completed, the crawl space can remain a dry and healthy space.
Being able to have a stable and fully supported home is essential to ensuring we feel safe. No one wants to experience sagging sub-floors or doors not closing properly because the base isn't supported. A home is held standing by two very important materials: the support beams and wooden posts in the crawl space. Every homeowner should make it a priority at keeping those two things away from moisture at all costs. Because they are only made of wood, if exposed to moisture damage they can absorb the water and it will cause the wood to rot. Once wood experiences water damage water patterns develop which distort and discolor the wood. If wood becomes rotten or splintered it can't be repaired, only replaced, which can be costly. We ensure protection of the wood in the crawl space by installing a CleanSpace vapor barrier between the concrete footing and the wooden posts. This isolates the wooden post and protects against water having access to it. Because the CleanSpace vapor barrier is made with 20 mil thick woven fibers, it has a durability to be tear resistant and really protect the wooden posts for years to come.
our service area